This Is How To Treat Ruptured Blisters And Remove Them Easily!

During summer and the work in the garden brings some blisters on our hands. The sandals we wear and expose the feet to the sun also brings blisters to our feet. Here is a simple way to treat ruptured blisters. The blisters appear when the upper layer of skin (the epidermis) detaches from the lower layers.
This is usually due to friction or heat, although some skin diseases or other medical conditions can cause blisters.
The space between the layers of the skin is filled with a liquid called “serum“, which is what gives it the appearance of a water balloon.
The blisters heal better when they do not burst or open because the layer of intact skin helps keep bacteria out of the wound and prevent infections.
Unfortunately, some blisters inevitably burst.
A ruptured blister can be difficult to clean and painful and needs some extra care to prevent infection. Luckily, there are some simple steps to take care of a burst blister and then control it to ensure its correct healing.
Treat a ruptured blister
-Wash your hands thoroughly. Use mild soap and warm water to wash your hands before touching the blistered area.
-Wash your hands for 15 to 20 seconds.
-This will help prevent the spread of germs, which could cause an infection in the area of the blister.
-Wash the area well with mild soap and water. Do not rub the blister, but you could break the skin more.
-Do not use alcohol, iodine or hydrogen peroxide as they can irritate exposed skin.
-Allow the ampoule to dry. Let it dry in the air, if possible, or gently dry with a towel. Do not rub the blistered area with the towel, but you could break the skin.
-Do not touch the hanging skin. The hanging skin formed by the surface of the blister falls over time but may help protect the new skin underneath while self-healing.
-If you can, leave it intact, and put it on top of the new skin.
-If the blister bursts, or if there is dirt under the hanging skin, you could trim it to prevent infection and keep it from rupturing and damaging healthy skin.
-First, wash the area well. Then disinfect a pair of small scissors (nail or first aid are the best) with isopropyl alcohol (you can also disinfect them by putting them in boiling water for 20 minutes or you can put them on an open fire until the metal is red hot, And then let them cool).
-Carefully cut dead skin. Do not cut yourself too close to the healthy skin. It is better to leave some skin than to risk further damage to the skin.
-Apply an antibacterial cream or ointment to the area. This will help prevent an infection, which is the greatest risk of ruptured blisters.
-Put a clean bandage on the blister. For smaller blisters, a common bandage will suffice, but for large blisters, you may need to put on a non-stick gauze with first aid tape
-Be sure to only wear non-adherent bandages and gauze over an open blister. Common gauze sticks to open skin!
-Use a special bandage for an open or especially painful blister. If the skin on the blister has gone out or if the blister is on your foot or another sensitive area, you may need to use a special blister band.
-There are numerous bandage marks with special blister pads that protect delicate skin.
-You can also put moles on the blisters. The molesquín is a soft and textured material of plush that usually has an adhesive surface. Cut 2 pieces of moleskin a little larger than the ampoule.
-Cut a circle about the size of the blister into one of the pieces. Put this piece on the blister so that the “window” is directly over the blister. Put the second piece on top of the first one.
-Resist the urge to use a liquid bandage. This type of bandage is more appropriate for cuts or lacerations, but over blisters can cause more irritation or infections.
If you have questions, ask your pharmacist or call your doctor for specific recommendations.
We hope you find this article helpful and you share it. Thank you!